|
|
Original Post By:
Fretted
|
Date: 4/21/2014 5:33:26 PM |
Do any of you fine ukiologists know which size allen wrench fits the truss rod on my PONO bari? |
|
|
|
|
|
|
|
Posted By:
Tom B.
|
Date: 4/24/2014 12:45:23 AM |
I adjusted one with a 5/32 Allen wrench, but the wrench had a little play. It was still tight enough to turn the rod, but the Pono probably takes a metric size. Not sure what metric size would be just larger than 5/32nds. By the way ... this was a surprise to me ... turning the truss rod counter-clockwise tightens it, and clockwise loosens it.
|
|
|
|
Posted By:
Frank B
|
Date: 4/24/2014 3:38:48 PM |
The metric hex wrench would probably be 4 mm.
If the truss rod tightens when turned counter-clockwise, then the threaded end of the trust rod has a left-handed thread. Not that it matters much to anyone other than an old machinist such as myself, but when I share minutia I like to be generous. Cheers.
|
|
|
|
Posted By:
Fretted
|
Date: 4/29/2014 4:43:06 PM
(Updated: 4/29/2014 4:43:45 PM)
|
Thanks, guys. The 5/32 worked and I was also surprised when it got tighter as I turned counter-clockwise, but then it seemed to tighten as well when I turned it the other way . . . after a few 1/4 turns. Weird.
|
|
|
|